 Posted 5/6/2008 4:12:20 PM
|
|
|
|
| We are getting water in our Federal Argent S2 lightbars, especially after going through a carwash. We have already sealed the large wiring hole an all but 2 drain holes. The water causes an alley light to stay on. Is this a common problem? If so, maybe we can get Federal to fix them.
|
|
|
Posted 5/7/2008 6:36:42 AM
|
|
|
|
| We have been using the Arjent's for about 5 years. I have 15 and have not had any water problems, yet.
|
|
|
Posted 6/11/2008 6:33:14 AM
|
|
|
|
| What "ROC" Boards are installed in your Argents, are they "A" or "B" Boards? (the easy way to check is if the Board has 3-Black wires on top, they are "A" Boards, there is also a Sticker on top that has the Information printed on it) I had replaced 7 boards for the Alley Light either staying on or would not come on, I contacted Federal and they sent me enough of the updated boards to replace all of the rest. I have 12 of these lightbars in use right now. Federal has a manufacturer defect with the Outer "A" Boards. Contact Federal's Service Department and talk to either Nick, Dave or Dereck in "Technical/Parts Identification" I am now working on the "Inner" boards now, with some of them, one or more of the LED Light Modules will come on when the Console Power is turned off and will go off when the Console Power is turned back on (we use a "Master Switch" in our Console wiring) This problem will drain the car's battery in a matter of hours. I hope this information helps
|
|
|
|